Fibroblast Plasma skin scar remove and eyelid lifting
Plasma Freckle removal pen work principle : similar as carbon dioxide (CO2) laser beauty equipment, it use new generation of plasma micro district discharge technology with low temperature and high frequency , it is efficient capacity conversion material and chip control . when the needle touch the freckle skin,it produce plasma with high temperature as 2000 ºC immedicately, then it can carbide the spot freckle , removal it.
When it touch the freckle ,spot ,it will produce a small flame,we called it carbide problem skin.The micro vascular will be solidified quicly without bleeding.Then it will formed carbon scabs ,protect wound skin from infection. After about 1 week, scab will sheeding without scar.
Removal spot, freckle ,verruca plana, flat warts, nervus sebaceous, granuloma,
skin neoplasm, fat granule, hemangioma, eyelid lift
Eyelid upper pen work with advanced over-current plasma fire, once touch organic stuff soon raise temperature to 755 -2000 degree centigrade,
max power 2500W to keep wound soon carbinization and soon reciver.However wound size only 0.06mm so without bleeding and scars.
• Remove completely: instantly get rid of skin neoplasms and strong antiseptic
• No bleeding, with the function of blood clotting
• Wound easy to recover
• No scar left
• Ease use: it can work for about 2-3 hours after 1 time charge.
• Economical and practical: it is cheap and needle can reuse.
• Easy to take
It produce high frequency current,biological tissue can be cutting, carbide.
The needle is soft with good flexibility.
Input: AC110V/60HZ AC220V/50HZ
with 3 needles free
Connect the charger to the end of the product, and then connect the power and charge, charging 2 hours can be used normally 10 to 15 days.
Environmental requirements and working conditions:
Ambient temperature: 0ºC~40ºC
Relative humidity: 45% ~ 77% ((no condensation)
The atmospheric pressure: 70kPa~106kPa
Applicable power: AC220V±22V 50Hz±1Hz
Single frequency: 1.1MHz±0.3MHz
The maximum output power: not less than 10W (peak value)
A. Once recieve package check accessories and equipment
B. Install needle
C. Connective power suply for the first tiime use
D. Testing equipment first, can use paper
E. Clean clients treatment location by alcohol, if sensor parts or big size treatment location use anesthetic cream
F. Start treatment, needle keep 1cm distand with treatment target
G. Finish treatment, apply aloe vera cream or keep it clean all ok .
1. connect device to power supply
2. Using alcohol to blot out the patient’s skin, for big size need to do surface anesthesia
3, keep patient stable and don;t move, people handle this instrument also need to keep hand stable.
4, Click the bottom to do treatment, for mole remove need to keep around 5mm distand away from effected area
5. After treatment need to use some anti-inflammatory drugs daub .
|Effective||Plasma pen||CO2 laser equipment|
|pigment remove||without bleeding, one time treat forever remove||One time treat pigment forever, feel hurt on treeatment|
|safety||micro place scanning hand control||when power bigger could make scar|
|pre-heating||turn on can be used||30 minutes pre-heating time|
|cool down||Do not need cool down||water cool down|
|service life||10 years||thousands hours|
|consumable||needle||CO2 laser lamp|
Source your reliable laser hair removal equipment suppliers and manufacturers here, we would meet your requirment with our best service and products.